-
ASK any questions before you buy!We have distributed PRO AUDIO SPEAKERS and Amplifiers for 20 years. Go to SpeakersAndAmps to see!We have all the other major PRO Audio Speaker Brands and Models.We have many many more than you see here. We sell to Dealers as well.
Description
Marani MPA-600T
| Outstanding Performance | High power output: 2x900 W @ 4 Ohm Highly efficient Switch-Mode Power Supply Class H output circuitry Full protection circuitry including Over-Current, Over/Under-Voltage, Output DC and Over-Temperature Two XLR Link outputs for use in driving additional power amplifiers. Excellent sonic performance with 24bit high end converters coupled with 48kHz sample rate |
| Top-grade DSP Engine | 28 band parametric equalization per channel, each band can be switched to Bell, Low/High Shelving variable Q 3 All Pass Filter, Bypass 1st order and 2nd order Crossover filters with slopes from 6dB/Octave up to 48dB/ Octave including Butterworth, Bessel, Linkwitz-Riley Precision dynamic range controller composed of a RMS Compressor with selectable ratio and variable knee Adjustable Delay time up to 900 ms per channel On each Channel is possible to use a two band RMS Compressor. Parametric Dynamic Filter Peak Limiter |
| Direct PC/Network Connection | Front panel USB connector for direct PC communications Ethernet interfaces (RS485 version also available) for system setup, monitoring and control via manageable remote PC software |
| Control | Front panel interactive LCD display for local access and configuration Front panel 5-LED level meter indicators per channel Simultaneous control up to 32 units via PC software Up to 20 storable user presets |
Power & Amplifier section
| Number of Channels | 2 |
| Output Modes | Stereo, Parallel-mono and Bridge-mono |
| Max Output Power | 2 x 600W @ 8Ω 2 x 1000W @ 4Ω |
| Output Circuitry | Classe H |
| THD @ Rated power 4Ω (1kHz) | <0.01% |
| Dynamic Range | 105 dB (A-weighted, AES-17 filter) |
| Frequency Response | 20Hz - 20kHz ±0.5 dB |
| Damping Factor | >200 (8Ω / 1kHz input signal) |
| Power Supplies | Switch mode power supply |
| Operating Range | 115V / 230V - 50/60 Hz (factory selection) |
| Consumption / Current draw and Thermal dissipation @ 230 V | 74.8W / 0.76A / 255 BTU/h (Idle) 963W / 6.5A / 3286 BTU/h (I/8 max. power@4Ω) 1260W / 7.8A / 4300BTU/h (I/4 max. power@4Ω) |
| Protections | Over-Current, Over/Under Voltage, Output DC and Over-Temperature |
| Analog Input | 2 x XLR electronically balanced, +12dB |
| Analog Output | 2 x XLR electronically balanced (Link) |
| Input Sensitivity | 0.775V, 1.2V, 1.6V |
| Frequency Response (DSP) | 20-20KHz; -0.5dBu at 20Hz and 20kHz |
DSP & Processing
| DSP Engine | MARANI M704 |
| DSP Resolution | 24bit (data) x 24 bit (coeff.),54bit accumulation registers, 96 bit precision on intermediate processing data |
| Parametric Equalization | 28 filters per channel selected as Bell or Shelving |
| Filter Type | Bell, Low/High Shelving variable Q |
| Filter Gain | From -12dBu up to +12dBu by 0.5dBu resolution steps |
| Center Frequency | Selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz |
| Bell Filter Q/BW | Q from 0.5 up to 10 by 0.1 resolution steps |
| Low/High ShelvingFilter Q | Q from 0.5 up to 3 by 0.1 resolution steps |
| Crossover Section HPF/LPF | Butterworth 6/12/18/24/36/48dB per octave Linkwitz-Riley 12/24/36/48dB per octave Bessel 12/24dB per octave Filter resolution 1/24th of octave |
| 3 All Pass Filters | Frequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz Type: Bypass, 1st Order, 2nd Order; Q: from 0.5 to 9.9 step 0.1 |
| Dynamic Filter | Frequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz Attenuation: from -6dB to 0dB; Q: from 0.1 to 10.0 step 0.1 |
| RMS Compressor | Threshold from -30dBfs up to 0dBfs Attack time from 5ms up to 500ms; Release time from 40ms up to 1 sec Ratio from 2:1 to 100:1; Knee from 0%(Hard Knee) to 100% (Soft Knee) Make-Up: +/-18dBu |
| Peak Limiter | Threshold from -30dBfs up to 0dBfs Release time from 40ms up to 1 sec; Attack time from 1ms up to 100ms. |
| Delay | 900 ms 21us increment/decrement steps per channel |
General
| Device Presets | 20 User Presets |
| Front Panel | 2x24 character LCD display with blue LED backlight 5-LED meter per channel (-6dB,-3dB, 0dB, limit, clip) Red LED (Protect) per channel NAV/PM1/LEVEL-A, NAV/PM2/LEVEL-B Rotary encoder push button switches Power on/off push button switch USB type B connector |
| Rear Panel | 2 x XLR female connector (Input) 2 x XLR male connector (Link Output) 2 x Neutrik® Speakon NL4 (Speaker Output) 2 x Binding Post output (In parallel with Speakon® connectors). 2 x EtherCon® RJ45 connector (M-LAN RS485) or Ethernet 10/100 TCP-IP (T version only) 1 x 3-position slide switch Output Mode (Stereo, Parallel, Bridge) 1 x 3-position slide switch Input Sensitivity (0.775V, 1.2V, 1.6V) AC Power Cord |
| Dimensions | 19"x 3.5"x 20.3" (483x89x515mm) 2RU |
| Weight, Net / Shipping | 33.07 lbs (15 Kg) / 41.89 lbs (19 Kg) |
ASK any questions before you buy!
Or go to SpeakersAndAmps dotcom
|
|
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.