Marani MPA-600T 900W 2 Channel Power Amplifier W/DSP AUTHORIZED DEALER!!!


Price:
Sale price$699.99

Description

Marani MPA-600T

Outstanding Performance High power output: 2x900 W @ 4 Ohm
Highly efficient Switch-Mode Power Supply
Class H output circuitry
Full protection circuitry including Over-Current, Over/Under-Voltage, Output DC and Over-Temperature
Two XLR Link outputs for use in driving additional power amplifiers.
Excellent sonic performance with 24bit high end converters coupled with 48kHz sample rate
Top-grade DSP Engine 28 band parametric equalization per channel, each band can be switched to Bell, Low/High Shelving variable Q
3 All Pass Filter, Bypass 1st order and  2nd order
Crossover filters with slopes from 6dB/Octave up to 48dB/ Octave including Butterworth, Bessel, Linkwitz-Riley
Precision dynamic range controller composed of a RMS Compressor with selectable ratio and variable knee
Adjustable Delay time up to 900 ms per channel
On each Channel is possible to use a two band RMS Compressor.
Parametric Dynamic Filter
Peak Limiter
Direct PC/Network Connection Front panel USB connector for direct PC communications
Ethernet   interfaces  (RS485  version  also  available)   for system   setup,   monitoring  and  control  via  manageable remote PC software 
Control Front panel interactive LCD display for local access and configuration
Front panel 5-LED level meter indicators per channel
Simultaneous control up to 32 units via PC software
Up to 20 storable user presets

Power & Amplifier section

Number of Channels 2
Output Modes Stereo, Parallel-mono and Bridge-mono
Max Output Power 2 x 600W @ 8             2 x 1000W @ 4      
Output Circuitry Classe H
THD @ Rated power 4 (1kHz) <0.01%
Dynamic Range 105 dB (A-weighted, AES-17 filter)
Frequency Response 20Hz - 20kHz ±0.5 dB
Damping Factor >200 (8Ω / 1kHz input signal)
Power Supplies Switch mode power supply
Operating Range 115V / 230V - 50/60 Hz (factory selection)
Consumption / Current draw and Thermal dissipation @ 230 V 74.8W / 0.76A / 255 BTU/h (Idle)   
963W / 6.5A / 3286 BTU/h (I/8 max. power@4Ω)                
1260W / 7.8A / 4300BTU/h (I/4 max. power@4Ω)
Protections Over-Current, Over/Under Voltage, Output DC and Over-Temperature
Analog Input 2 x XLR electronically balanced, +12dB
Analog Output 2 x XLR electronically balanced (Link)
Input Sensitivity 0.775V, 1.2V, 1.6V
Frequency Response (DSP) 20-20KHz; -0.5dBu at 20Hz and 20kHz

DSP & Processing

DSP Engine MARANI M704 
DSP Resolution 24bit (data) x 24 bit (coeff.),54bit accumulation registers,  96 bit precision on intermediate processing data 
Parametric Equalization 28 filters per channel selected as Bell or Shelving  
Filter Type Bell, Low/High Shelving variable Q
Filter Gain From -12dBu up to +12dBu by 0.5dBu resolution steps
Center Frequency Selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz
Bell Filter Q/BW Q from 0.5 up to 10 by 0.1 resolution steps
Low/High ShelvingFilter Q Q from 0.5 up to 3 by 0.1 resolution steps 
Crossover Section HPF/LPF Butterworth 6/12/18/24/36/48dB per octave
Linkwitz-Riley 12/24/36/48dB per octave
Bessel 12/24dB per octave
Filter resolution 1/24th of octave
3 All Pass Filters Frequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz
Type: Bypass, 1st Order, 2nd Order; Q: from 0.5 to 9.9 step 0.1
Dynamic Filter Frequency selectable with a 1/24th of octave resolution step from 20Hz up to 20kHz
Attenuation: from -6dB to 0dB; Q: from 0.1 to 10.0 step 0.1
RMS Compressor Threshold from -30dBfs up to 0dBfs
Attack time from 5ms up to 500ms; Release time from 40ms up to 1 sec
Ratio from 2:1 to 100:1; Knee from 0%(Hard Knee) to 100% (Soft Knee)
Make-Up: +/-18dBu
Peak Limiter Threshold from -30dBfs up to 0dBfs
Release time from 40ms up to 1 sec; Attack time from 1ms up to 100ms.
Delay 900 ms 21us increment/decrement steps per channel

General

Device Presets 20 User Presets
Front Panel 2x24 character LCD display with blue LED backlight
5-LED meter per channel (-6dB,-3dB, 0dB, limit, clip)
Red LED (Protect) per channel
NAV/PM1/LEVEL-A, NAV/PM2/LEVEL-B Rotary encoder push button switches
Power on/off push button switch
USB type B connector
Rear Panel 2 x XLR female connector (Input)
2 x XLR male connector (Link Output)
2 x Neutrik® Speakon NL4 (Speaker Output)
2 x Binding Post output (In parallel with Speakon® connectors).
2 x EtherCon® RJ45 connector (M-LAN RS485) or Ethernet 10/100 TCP-IP (T version only)
1 x 3-position slide switch Output Mode (Stereo, Parallel, Bridge)
1 x 3-position slide switch Input Sensitivity (0.775V, 1.2V, 1.6V)
AC Power Cord
Dimensions 19"x 3.5"x 20.3" (483x89x515mm) 2RU
Weight, Net / Shipping 33.07 lbs (15 Kg) / 41.89 lbs (19 Kg)
ASK any questions before you buy!
Or go to SpeakersAndAmps dotcom   



  • ASK any questions before you buy!
    We have distributed PRO AUDIO SPEAKERS and Amplifiers for 20 years.  Go to SpeakersAndAmps to see!
    We have all the other major PRO Audio Speaker Brands and Models.
    We have many many more than you see here.  We sell to Dealers as well.

Payment & Security

PayPal Venmo

Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

You may also like

Recently viewed